Filter
Top Products
33
mkt3048 9921700000 Rev C
V I I . O P E R A T I N G I N S T R U C T I O N S
Y. LATERAL TRUNK SUPPORT MOUNTING (OPTIONAL)
OPERATING AND ADJUSTMENT.
Lateral Swing Away Operation: (See Fig.3)
1. Depress the silver lever (a) (See Fig.3) allowing the
lateral to swing inwards or outwards. This is useful
for storage or helping a child into or out of the
seating system.
NOTE* the laterals lock into the adjusted preset
position.
LATERAL HEIGHT AND WIDTH ADJUSTMENT: (SEE
FIG.1) PAGE 32
NOTE* It is not necessary to remove the child from
the seating shell.
1. Open the rear cover to access the adjustment screws.
2. Loosen the mounting screws (a) (See Fig.1) page
32 from the rear of the shell only enough to gain
movement of the laterals. Adjust the pads for height
and width bringing the pads to the correct position.
3. Tighten firmly.
LATERAL LENGTH ADJUSTMENT: (SEE FIG.4)
1. Slide the lateral cover and foam forward or remove
to expose adjustment screws
2. Loosen screws (b) and move lateral to proper
length
3. Tighten screws and replace the foam and cover.
Lateral Lock Angle Adjustment
Note* this adjustment may be able to be
accomplished with the child in the seating system.
LATERAL ROTATION ADJUSTMENT: (SEE FIG.5)
1. Lock the lateral by rotating inwards
2. Loosen the angle lock screw (c) (See Fig.5) shown on
the top of the lateral hinge point
3. Adjust angle to the appropriate position and tighten.
Figure 5
Figure 4
B
C
Figure 3