Filter
Top Products
29
mkt3048 9921700000 Rev C
R. BACK POSITIONING PLATE HEIGHT ADJUSTMENT
1. Open the exterior back panel fabric sections on the outside
to expose the back growth slots and adjustment screws.
2. Loosen the screws through the access holes (a) (See Fig. 21)
behind the back plate on each side, adjust to proper height.
Tighten and retighten both adjustment screws (See Fig. 21)
S. BACK CUSHION HEIGHT ADJUSTMENT
1. Fit the back cushion to the positioning plate at proper height.
2. Add appropriate back cushion growth inserts if a gap is present at the bottom of the back cushion.
T. FOOTBED ADJUSTMENTS
Height Adjustment
Two telescoping tube sections and locks control footbed height.
1. Identify adjustment screw locations on the rear side of the
footbed hanger.
2. Loosen upper screw on each side of the footbed hanger. (See
Fig. 22)
3. Slide the footbed up or down to proper height.
4. Tighten both screws.
5. Repeat procedure using lower screw in step 2 if additional
range
is required.
Angle Adjustment
1. The footbed has two screws that fit into a series of holes in
the footbed sides and two more that allow footbed rotation.
Remove the footbed angle adjustment screw on each side of
the footbed.
(See Fig. 23)
2. Adjust the footbed to proper angle and align nearest
adjustment holes with the footbed couplers.
Install adjustment screws through footbed and into footbed
coupler to maintain proper footbed angle.
V I I . O P E R A T I N G I N S T R U C T I O N S
Figure 21
Figure 22
Figure 23