Sunrise Medical Xpress Stroller User Manual


 
28
9921700000 Rev C mkt3048
V I I . O P E R A T I N G I N S T R U C T I O N S
Adding growth strips:
1. Unzip seat cover and fold the top over the front edge to expose the cushion.
2. Lift the foam overlay piece away from the velcro attachment, using care not to tear the foam.
3. Grasp the rear foam section at the middle and lift it from the velcro attachment.
4. Add the either the 1 1/2" or the 3" growth strip at the back of the front foam section assuring
that the angled edges and sides align.
Note: Never use both growth strips at the same time.
5. Re-attach the rear section assuring the angled edges and sides align.
6. Adjust the adductor wedges as needed and position the foam overlay over the cushion and attach
to the velcro at the rear of the seat.
7. Close the zipper around the cushion and install into the unit.
Cleaning the seat cover:
1. Unzip the cover along the edge.
2. Remove the cushion assembly from the velcro attachment inside the cover.
3. The fabric seat cover should be hand washed in laundry soap, thoroughly rinsed with clean water
and air dried.
4. The foam cushion pieces may be wiped down with soap and water. Always be sure they are com-
pletely dry before replacing the fabric cover.
5. Place the cushion into the fabric cover onto the velcro with the front edge of the cushion aligned
with the front edge of the cover.
6. Pull the cover over the cushion and close the zipper around the cover.
Q. STANDARD CUSHION WITHOUT LATERAL HIP SUPPORT
The standard Cushion without-Lateral Hip Supports comes in two seat lengths, short and long.
The short seat is 7" long with capability for adding a 2" growth strip at the back of the cushion.
The long seat is 9" long with capability for adding a 2" growth strip at the back of the cushion.