Filter
Top Products
18
STORAGE
Store the AeroPilates Pro XP686 in a clean, dry place.
It is recommended that two people be available to move the AeroPilates Pro XP686.
To move the AeroPilates
Pro XP686: First, attach one of the TENSION SPRINGS(66, 67 or 68) to
the EYEHOOK(70) on the SPRING BAR(71) to prevent the CARRIAGE(42) from moving. Second,
grasp the HANDRAIL(30) and lift the unit from the back. Third, roll the AeroPilates
Pro XP686 on the
moving wheels that are attached to the FRONT FRAME(1).
1.
2.
3.
MAINTENANCE
The safety and integrity designed into the AeroPilates Pro XP686 can only be maintained when the
AeroPilates
Pro XP686 is regularly examined for damage and wear. Special attention should be given to
the following:
OPERATIONAL INSTRUCTIONS
SHOULDER PAD ADJUSTMENT
The posts on the bottom of the SHOULDER PAD SUPPORTS
(117, 118) are offset so you can install the supports in two
positions. One position is one inch wider to accommodate
broader shoulders, another position is for narrower shoulders.
To adjust, switch the position of the SHOULDER PAD
SUPPORTS(117, 118) and secure with the HANDLEBAR
(119).
It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
Worn or damaged components should be replaced immediately or the AeroPilates
Pro XP686 removed
from service until repair is made.
Verify that the Warning Label is present and legible. Replace the Warning Label if it is missing or
damaged.
Verify that the ROPES(63) are properly installed on the PULLEY SETS(40).
Check the condition of the ROPES(63) and replace if they are frayed or worn.
Check the condition of the TENSION SPRINGS(66, 67, 68). Replace the springs that are damaged.
Check the BUNGEE CORD(78) on the CARDIO REBOUNDER(76) for wear. Replace the CARDIO
REBOUNDER(76) if the BUNGEE CORD(78) is frayed or worn.
Check the PULLEY SETS(40) for excessive wear. Replace worn PULLEY SETS(40).
Check the HAND STRAPS(65) for damage. Replace damaged parts.
Check the FOAM GRIPS(21), FOAM TUBE(23), SHORT FOAM TUBES(57), and
SHOULDER PADS
(84) and replace if damaged or worn.
Check the GUIDE SPACERS(16) and BUMPERS(19) for looseness or damage and replace any damaged
parts.
Check the CUSHION(53) and replace if it is damaged or worn.
Check and clean the ROLLERS(47) and SIDE ROLLERS(48) and the rolling surfaces on the rails.
Clean by wiping with a dry cloth.
Only Stamina Products supplied components shall be used to maintain/repair the AeroPilates
Pro
XP686.
Keep your AeroPilates
Pro XP686 clean by wiping with an absorbent cloth after use.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.