Filter
Top Products
Configuring the V2IU 4350
3 - 61
2. Select System Overview.
3. Select VoIP Subnet Routing.
4. Enter the IP Network (e.g. 10.10.12.0).
This is the IP address of the remote subnet containing the voice devices.
5. Enter the Netmask (e.g. 255.255.255.0).
This is the mask of the IP address of the subnet containing the voice
devices.
6. Enter the Gateway (e.g. 10.10.10.2).
7. This is the IP address of the intermediate router that knows the return
path to the remote subnet from the 4350.
8. Select the Delete Subnet checkbox.
9. Press Submit.
Perform steps 1 through 8 for each remote subnet that you wish to delete.
Configure IP Phones, IADs or Softphones
After configuring the 4350 VoIP ALG the voice devices must be configured to
point to the LAN interface of the 4350 as their signaling gateway and
optionally as their TFTP server (if they use the TFTP protocol to retrieve their
software images). The steps required to setup these devices differ from vendor
to vendor. Using the DHCP server included in the 4350 will significantly
simplify the setup of these devices if they are able to obtain their IP
configuration via DHCP. Please consult the applicable users guide of each
device for detailed instructions.