Filter
Top Products
User Manual V
2
IU 4350 Converged Network Appliance
2 - 2
• If the T1/E1 port will be used to connect to WAN:
— T1 cable to connect the T1/E1 port to a T1 line.
• Ethernet cables to connect the LAN ports to LAN switches or to individual
IP phones. They can also be used to connect the Ethernet WAN port to a
WAN router, a Cable Modem or a DSL Modem, if T1/E1 port is not being
used to connect to the WAN.
Desktop Installation
1. Remove the 4350 and accessories from the shipping container.
2. Place the 4350 on a flat, dry surface such as a desktop, shelf or tray.
3. Connect the power and network cables to the appropriate ports on the
back of the system.
Wall-Mount Installation
1. The 4350 can be wall-mounted using the two mounting brackets on the
bottom of the appliance. We recommend using two round or pan head
screws.
2. Install two screws 5.9" (150 mm) horizontally apart on a wall or other
vertical surface. The screws should protrude from the wall so that you
can fit the appliance between the head of the screw and the wall. If you
install the screws in drywall, use hollow wall anchors to ensure that the
unit does not pull from the wall due to prolonged strain from the cable
and power connectors.
3. Remove the 4350 and accessories from the shipping container.
Warning
To reduce the risk of fire, use only 26 AWG or larger wire (e.g. 24, 22, 20, etc.) to
connect the T1 port on your unit to an RJ-45 jack.
Caution
To reduce the risk of fire, use only 26 AWG or larger wire (e.g. 24, 22, 20, etc.) to
connect the T1 port on your unit to an RJ-45 jack.