Filter
Top Products
invision Serial/Modem Charging Cradle User Guide
Appendix A – Regulatory Information
Radio Frequency Interference Requirement
FCC Statement
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected
• Consult the dealer or an experienced radio or television technician for
help.
Changes or modifications not expressly approved by Mobility Electronics could void the
user’s authority to operate the product.
Radio Frequency Interference Requirement - Canada
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
Telecom Compliance, Warnings, and Notices
United States
The applicable regulatory notices for the United States include:
• This equipment complies with Part 68 of the FCC rules and requirements adopted by
ACTA. On the bottom of this equipment is a label that contains a product identifier in
the format US: AAAEQ##TXXXX. If requested, this number must be provided to the
telephone company.
• The Ringer Equivalency Number (REN) determines the number of devices that may
be connected to a telephone line. Excessive RENs on a telephone line may result in
devices not ringing in response to an incoming call. In most areas, the sum of RENs
should not exceed five (5.0). The REN for this product is part of the product identifier
that has the format US: AAAEQ##TXXXX. The digits represented by ## are the REN
without a decimal point.
• This equipment must be connected to the telephone network or premises wiring
using a compatible modular jack (RJ11C) compliant with the applicable FCC Part 68
rules and requirements adopted by ACTA. A compliant telephone cord and modular
plug are provided with this product. It is designed to be connected to a compatible
modular jack that is also compliant.
• If this equipment, the Serial/Modem Charging Cradle PS6S1800M, causes harm to
the telephone network, the telephone company will notify you in advance that
11
Mobility Electronics, Inc