Filter
Top Products
invision Serial/Modem Charging Cradle User Guide
Symptom: Attempt by the cradle to HotSync the terminal through the modem
failed.
Possible Cause Action
The terminal was removed from the
cradle while the HotSync was in
progress.
Place the terminal back in the cradle to allow the
cradle to make another HotSync attempt.
Terminal or cradle was disconnected from
the telephone line while the HotSync was
in progress.
Unplug the modem cable for 30 seconds to allow
the local telephone connection to hang up. Be
sure to close any open windows on the terminal
and any modem connections.
Terminal’s battery is dead. Wait for two (2) minutes before trying a HotSync
again to allow the battery to recharge.
Active Error dialog box on terminal. The Error dialog box on the terminal must be
cleared. Use the stylus to press “OK” on the
terminal’s touchscreen.
Modem or telephone lines being operated
in an electrically noisy environment.
Modify init string in US/Canada to “AT&F\N5”
forcing MNP error correction, or
“AT&F+MS=V32B” forcing B32bis (14,400 bps)
connection.
For International operation use
“AT&F\N5;+GCI=xx;” forcing MNP error
correction or “AT&F+MS=V32B;+GCI=xx;”
forcing V32bis (14,400 bps) connection.
8
Mobility Electronics, Inc