Filter
Top Products
Black plate (268,1)
3. Turn the screws and the center section
of the plastic retainers
counterclockwise and remove them,
then partially peel back the mudguard.
Removal
Installation
4. Turn the socket and bulb assembly
counterclockwise and remove it.
5. Disconnect the bulb from the socket.
6. Install the new bulb in the reverse order
of removal.
Side turn signal lights
1. Make sure the ignition is switched off
and the headlight switch is off.
2. Slide the unit as shown in the figur e to
remove it.
3. Detach the electrical connector from
the unit by pulling it outward.
4. Install the new side turn signal unit in
the reverse order of removal.
NOTE
Bulb replacement is not possible because it is
built into the unit. Replace the unit.
8-36
Maintenance andCare
Owner Maintenance
Mazda2_8BL3-EA-10E_Edition3 Page268
Wednesday, September 29 2010 3:53 PM
Form No.8BL3-EA-10E