Filter
Top Products
58 59
21.1 Storing Lower Anchors and Tether (LATCH)
Storage bars located
on each side at the
back of the seat
Tether
Lower
anchors
Lower
anchors
1. For ease of storing, extend LATCH to its
maximum length.
2. Locate the storage bars on back of
child restraint
.
3. Fasten ends of tether and lower anchors
onto their respective storage bars as shown
.
4. Tether and lower anchors storage should
look like this when complete
.
21.0 Using the Tether
1. Check that tether is securely attached to
child restraint.
2. Fasten tether clip to anchor point .
3. Tighten adjustment belt to remove any slack .
4. To loosen, push button while pulling on the belt
as shown .
All LATCH seating positions have tether anchors. Always use tether if a vehicle tether anchor is
available, check your vehicle owner’s manual for the tether anchor location(s). If your vehicle is
not equipped with a tether anchor, it may be possible to install one. Contact your vehicle
dealership for the proper anchor location and installation.
You may purchase tether anchor parts kit by calling Graco Customer Service at 1-800-345-4109.