Filter
Top Products
28 29
10.0 Using Child Restraint WITH Built-in Harness
1. Loosen the harness straps by lifting the
harness adjuster lever at front of seat near
the adjustment strap and pulling the straps
toward you .
2. Open harness clip .
FAILURE TO PROPERLY ADJUST THE HARNESS STRAPS
FOR YOUR CHILD INCREASES THE RISK OF SERIOUS
INJURY OR DEATH IN THE EVENT OF A SHARP TURN,
SUDDEN STOP OR CRASH. Snugly adjust the belts provided with this child restraint around your
child. A snug strap should not allow any slack. It lies in a relatively straight line without sagging. It
does not press on the child’s flesh or push the child’s body into an unnatural position.
9.2 LATCH System
LATCH consists of a permanently
attached lower anchor belt and a top
tether strap.
ONLY use LATCH in a seating
position recommended by vehicle
manufacturer.
LATCH lower vehicle anchor points
are defined as 11 inches from the
center of one LATCH anchor to the
center of another LATCH anchor.
If allowed by your Vehicle Owners
Manual, the center seating position
maybe used if the anchor spacing is
11” or greater.
Child Restraint
Top Tether
Vehicle Top Tether
Anchor Point
Vehicle Lower
Anchor Points
Lower
Anchor Belt