Filter
Top Products
38 39
5. The harness straps must be even with or
Must above the shoulders .
To adjust head support/harness strap height
see page 39.
6. Make sure straps are flat and snug
against child’s shoulders and thighs.
You should not be able to pinch the
harness straps. A snug strap should not allow
any slack. It lies in a relatively straight line
without sagging. It does not press on the child’s
flesh or push the child’s body into an unnatural
position.
CHECK that child’s ears are BELOW top of
head support. If tops of ears are above top of
head support, child is too large for harnessed
use.
13.0 Adjusting Head Support/Harness Straps
When using with built-in harness always
use one of the bottom 4 height positions.
BEFORE adjusting the head support height,
have your child lean forward slightly.
Squeeze the red adjustment handle
on
top of seat and pull head support up until it
snaps into one of the bottom 4 height
positions
.
To lower, squeeze red adjustment handle
and push down.
CHECK to make sure it is securely snapped
into one of the bottom 4 height positions by
pulling up on head support.
The harness straps must be even with or
just above the shoulders as shown by dotted
line
.