Filter
Top Products
22 23
8.5 With OR Without Built-in Harness
Combination LapShoulder Belt with
Locking Latch Plate
Once it is buckled, this type of belt has a
latchplate that will not allow the lap portion
of the belt to loosen. Belt is tightened by
pulling hard on the shoulder portion of the
vehicle belt while pushing down hard on
the child restraint.
Combination LapShoulder Belt with
Sliding Latch Plate This belt has a
latchplate that slides freely along
the belt.
This belt MUST be converted to prevent
movement of the lap portion of the belt. You
must use the locking clip provided with the
child restraint, unless your vehicle's seat
belt can be converted in another way as
described in your vehicle owner's manual.
When using booster seat WITHOUT the
built-in harness, locking clip is NOT
to be used.
Locking clip
8.6 To Install Locking Clip
1. Tighten the buckled belt by pushing down hard on the child restraint and pulling hard on the
shoulder belt.
2. While pushing down on seat, pinch the two straps together behind the buckle tongue. Unbuckle
the belt without allowing it to slip.
3. Attach locking clip to lap and shoulder belts as shown .
4. Re buckle belt. Check that lap belt does not move
by pulling hard. If belt loosens or lengthens, repeat
procedure.
Remove locking clip when not using child restraint. Store
under it’s tab on the rear of seat.
Test installation to see if child restraint is secure.
If not secure, additional belt tightening may be required:
Unbuckle vehicle seat belt.
Hold belts together and remove locking clip.
Shorten length of lap belt portion slightly by pulling belt
through latch plate. Re-attach locking clip.
Buckle vehicle seat belt. Press child restraint further down
into vehicle seat cushion to help buckle vehicle seat belt. Test
installation to see if child restraint is secure. If not secure,
repeat above steps until secure.
12” (1.25 cm)