Filter
Top Products
7
FVR-C9S-2UX
1. Type
2. Phase: 3PH - three-phase
3. Voltage range: 200V - 230V - AC200V
Series
4. Frequency: 50/60Hz
5. Rated output capacity
6. Rated output current
7. Output frequency range: 1- 120 Hz
8. Serial No.
2. Part Names
1. Drive Cover
2. Keypad Panel
3. Frequency Setting VR
4. Mounting Screw Holes
5. Drive Cover Screw
3. Warning and Caution
Improper wiring will result in damage to, and
failure of the unit. Please carefully note the
items listed below, and use the unit as indi-
cated.
WARNING AND CAUTION
1. Do not impress power supply voltage that
exceeds the standard specification volt-
age permissible fluctuation. (Permissible
voltage: AC200V - 230V)
2. Do not connect power supply to the drive
output terminals (U, V, W). Connect power
supply only to the power terminals (L1, L2
and L3)
3. Whenever removing the drive cover, al-
ways switch off the power supply. Do not
switch on the power supply to the drive
with the drive cover removed.
4. Do not touch the live part until the CRG
lamp located above the main circuit termi-
nals goes out.
5. Avoid using a magnetic contactor (ON/
OFF) installed in the line side of the drive
for RUN and STOP. Use the FWD-CM
(forward) and REV-CM (reverse) terminals
for RUN and STOP.
6. Do not connect a power factor correcting
capacitor to the output side of the drive.
7. Do not perform a megger test between
the drive terminals or on the control circuit
terminals.
F V R F 2 5 C 9 S 2 U X
Drive Series
Applicable motor output (Hp)
Power Series: 230V UX Series
PRG
RESET
FUNC
DATA
RUN
STOP
CLOSED
OPEN
FVR-C9S
1
2
4
3
5
4