Filter
Top Products
36
37
1
Position Carrier rear facing on
vehicle seat, with child properly
secured in Carrier.
2
Route Vehicle Belt under
both Belt Guides, and buckle the
vehicle belt.
3
Tighten Vehicle Belt while
pushing Carrier firmly into
vehicle seat.
A tightly rolled towel may be used
under the front edge of the Carrier if
needed for stable, secure installation.
4
Check Installation:
a
Level Line on Carrier MUST
be LEVEL with ground.
b
Vehicle belt MUST be TIGHT.
c
Carrier MUST be STABLE
and secure.
Uninstalling Base
Remove Carrier from Base
1
Loosen LATCH by lifting the
LATCH Release Lever and pulling
Base away from vehicle seat back.
2
Detach LATCH Connectors
by pressing the red button on each
LATCH Connector, and remove
Base from vehicle.
Storing LATCH
Insert LATCH Connectors into
storage pockets.
a
1
Pull LATCH Pull Strap to
secure LATCH Connectors.
2
Roll LATCH Pull Strap and
store in Pull Strap Storage Pocket.
NEVER travel with CHILD RESTRAINT unsecured in vehicle.
Passengers may be injured during a sudden stop or crash.
When not using LATCH, the LATCH Connectors and Pull Strap
MUST be stored properly.
1
2
1
a
2
a
INSTALLATION WITHOUT BASE
NEVER install CARRIER without Base using a non-locking
ELR vehicle belt. The installation will NOT be secure. Refer to
your vehicle owner’s manual for detailed vehicle belt information.
INSTALLATION USING LATCH
a
b
2
3 4