Filter
Top Products
20
21
Use Newborn Insert to provide
additional support and ensure
a secure harness fit for smaller
infants.
To Install Insert in Carrier
1
Pull End of Buckle through
center slot in insert.
2
Pull Both Harness Straps
over and around side panels. Push
insert firmly into bottom of carrier.
3
When properly installed,
the Newborn Insert and harness
should look like drawing.
1
ONLY USE Insert with infants who weigh between 4 and 11
lbs. NEVER USE Insert if child weighs more than 11 lbs!
2
3
NEWBORN INSERT
To Adjust Canopy, grab bow on both
sides and rotate. Detach fastener tabs
when rotating toward front of carrier.
a
To Remove Canopy Fabric, pull
fabric away from Canopy Mount to
expose button. Press button on canopy
mount to release end of bow. Slide
canopy fabric off bow and detach
canopy from rear of pad.
To replace canopy, reverse previous
steps.
To extend/retract visor
b
To retract the visor, gently push it
downward and allow it to pop up under
the canopy. The canopy must be
extended before attempting to retract
the visor.
c
To extend the visor, gently pull
it downward from underneath the
canopy and allow it to pop up in its
extended position.
CANOPY
a
The harness height may
have to be changed to fit your
child. Before using insert, read
the instructions on “Changing
Harness Height” and “Securing
Child in Carrier”
Top of insert should always be
BELOW the lower harness slots.
b
c
Release bow from canopy
mount on opposite side of carrier
if using carrier without canopy.