Filter
Top Products
32
33
1
Position Base in forward facing
vehicle seat with Recline Foot
against seat back.
2
Adjust Base Angle by pushing
Recline Buttons while lifting Base.
Angle is correct when Bubble is
between arrows.
Vehicle must be on a level surface for
the Bubble to indicate correctly.
3
Route Vehicle Belt through
openings in Base and buckle
the vehicle belt. (Do not put the
shoulder belt in locked mode.)
4
Tighten Vehicle Belt while
pushing Base firmly into vehicle
seat.
5
Secure Vehicle Shoulder Belt
firmly under Shoulder Belt Lockoff,
while keeping tension on Belt. Only
use the lockoff on the opposite
side of the buckle.
1
INSTALLATION USING VEHICLE BELT
LATCH or Vehicle Belt? This Child Restraint can
be safely installed using Vehicle Belts or LATCH.
Use the method that results in the MOST
SECURE installation in your vehicle.
2
3
4
6
CHECK Installation:
a
Belts MUST be TIGHT.
b
Base MUST be STABLE.
c
Bubble MUST be
between arrows.
d
Belts & Buckles MUST NOT
INTERFERE with attachment
of Carrier to Base.
7
Attach Carrier To Base after
properly securing child in Carrier.
Uninstalling Base:
Remove Carrier from Base,
unbuckle Vehicle Belt, and remove
Base from vehicle.
7
NEVER travel with Child Restraint unsecured in vehicle.
Passengers may be injured during a sudden stop or crash.
INSTALLATION USING VEHICLE BELT
5
If using Vehicle Lap Belt only
(no Shoulder Belt), make sure
that Lap Belt is LOCKED, and
that free end of Lap Belt is
neatly stored so it DOES NOT
INTERFERE with attachment
of Carrier to Base.
6
ALWAYS lift up on Carrier
to verify it is properly attached
to the Base.