Filter
Top Products
34
35
1
Remove LATCH Connectors
from storage pockets while lifting
up on LATCH Release Lever.
2
Position Base in forward facing
vehicle seat with Recline Foot
against seat back.
3
Adjust Base Angle by pushing
Recline Buttons while lifting Base.
Angle is correct when Bubble is
between arrows.
Vehicle must be on a level surface for
the Bubble to indicate correctly.
4
Attach LATCH Connectors by
pushing them firmly onto vehicle
LATCH Anchor Bars. Verify
connection is secure by pulling
firmly on LATCH straps.
2
3
This child restraint base is designed to be used with lower LATCH
anchors at the standard spacing (11 inches) ONLY! Refer to vehicle owner’s
manual for information about LATCH and child restraint installation positions.
4
CLICK!
INSTALLATION USING LATCH
5
Tighten LATCH Belts by
pulling up firmly on LATCH Pull
Strap while pressing Base firmly
into vehicle seat.
6
Store LATCH Pull Strap neatly
in Pull Strap Storage Pocket.
7
Check Installation
a
LATCH belts MUST be
TIGHT
b
Base MUST be STABLE
c
Bubble MUST be
between arrows
d
LATCH Pull Strap MUST
NOT interfere with
attachment of Carrier
to Base.
8
Attach Carrier to Base after
properly securing child in Carrier.
8
5
7
6
1
LATCH or Vehicle Belt? This Child Restraint can
be safely installed using Vehicle Belts or LATCH.
Use the method that results in the MOST
SECURE installation in your vehicle.
INSTALLATION USING LATCH
ALWAYS lift up on Carrier
to verify it is properly attached
to the Base.