Filter
Top Products
Operating Instructions
COLORado™ 3P User Manual 21 3/17/2009 9:54 AM
Important Notes about Stage 1 Mode 1
Red, Green and Blue Selection
Channels 1, 2 and 3 control overall intensity of each respective color.
Channels 1, 2 and 3 can be combined to create an unlimited range of colors.
Channels 1, 2 and 3 have priority over Channels 4, 5, 6 and 7.
Yellow, Cyan, Purple and White
These colors can not be mixed.
When levels are raised on more than one of these channels, the lowest channel number
will have priority.
Strobe
Strobe occurs at every channel with exception to programs on Channel 9 and 12.
Speed of the strobe is adjustable from 0 to 20 Hz.
Mode Selection
Channel 9 values 5-244 provides mode selection and can only be activated while
Channels 1 through 7 are at value 0. When channel 9 is between 245 and 255, channels
1 through 7 can be any value.
When Color-Cycle mode 4 is selected channel 11 controls the speed.
ID address selection
Use channel 10 to select ID addressed fixtures.
Each independent DMX address can have up to 66 ID addressed fixtures.
ID address “0” allows control of all fixtures simultaneously.
Module selection
Provides individual control of the three LED modules in each fixture.
Channel 11 has priority over channel 12.
Effect macro
These are pre-programmed color patterns and module chases.
Channel 12 has priority over channels (1, 2, 3, 4, 5, 6 & 7).
Channel 12 has priority over channel 11 if first activated.