Filter
Top Products
8
3.0 Optional Permanent Bonding of Runner Sections with Adhesive
Note: Permanent adhering of the runner sections together with an adhesive may create a continuous
runner that is very heavy and difficult to move or reposition. Trying to move a heavy runner may
cause the rubber or the seams to tear, so use caution when deciding to permanently adhere runner
seams together.
1. Proceed through step 5 as described in the previous section in the Runner
Assembly Instructions, connecting the first section of the 3M
™
Anti-Fatigue
Mat Runner 9910 Series to the second section of the runner as illustrated.
After the first two sections are connected, push the second section away from
you to produce a gap/opening in the seam. (Figures 1 & 2)
2. Insert the tip of the supplied adhesive bottle into the seam, applying a small
bead of adhesive along the edge of the top surface of the mat section facing
you. (Figure 3)
3. Using the palms of your hands again, move quickly to pull the runner section
together, pulling and patting the runner towards you to get the seam to close.
(Figures 4 & 5)
To reduce the risk associated with back strain due to the heavy weight of the mats:
• Follow safe lifting procedures during installation or moving.
WARNING:
Figure 1 Figure 2
Figure 4
Figure 3
Figure 5