Settings You Can Change with User Tools
85
4
• Photo
You can configure the machine
to copy originals with photo-
graphs.
Note
❒ Default: Print Photo
❒
Select
[Print Photo]
when copy-
ing
originals with photo-
graphs such as magazines or
catalogues. A smooth finish
image can be reproduced.
❒ Select [Glossy Photo] when
copying developed photo-
graphs. The text contained
within the photographs can
be reproduced appropriate-
ly.
• Background Lines
Note
❒ Default: Normal
• Patched Original
Note
❒ Default: Pale
❖
❖❖
❖ Image Density
Specifies the copy image density
for each original type (Text, Draw-
ing, Text/Photo, Photo, Back-
ground Lines, Patched Original,
Generation Copy).
Note
❒ Default: Normal
❖
❖❖
❖ Change Initial Mode
You can select standard mode or
Program No.10 as the mode effec-
tive when power is turned on, or
modes are cleared.
Note
❒ Default: Standard
❖
❖❖
❖ Max. Copy Quantity
Specifies the maximum number of
copies that can be set.
Note
❒ Default: 99 sheets
❒ The number can be set from 1 to
99 sheets using the number
keys.
❖
❖❖
❖ Job End Call
You can choose to have the beeper
sound when copying is complete.
Note
❒ Default: On
❒ If Panel Tone of User Tools (Sys-
tem Settings) settings is [On], the
machine beeps to notify you
that it did not complete a job for
reasons such as: the paper tray
ran out of paper, or a paper mis-
feed occurred. See “Panel
Tone”, General Settings Guide.
Reproduction Ratio
❖
❖❖
❖ Custom Magnification Settings 1–3
You can store up to three repro-
duction ratios, and have them
shown on the initial display. You
can also change registered Reduce
/ Enlarge ratios.
Enter the reproduction ratio using
the number keys.
The value can be set from 25.0% to
400.0%.
Use the {
{{
{·}
}}
} key to enter a decimal
point.
Note
❒ Default:
• Metric version:
• Settings 1: 70.7%
• Settings 2: 100%
• Settings 3: 141.4%
DolphinC2_ENcopy_F_FM.book Page 85 Friday, February 25, 2005 10:46 AM
