Troubleshooting
68
3
Check paper size.
The size of the paper loaded is
different to the size of the
copy paper size.
Check the settings for Re-
duce/Enlarge, etc., and then
try again.
Rotate Sort is not
available with this
image size.
Select another paper
size or cancel Ro-
tate Sort mode.
The scanned original is too big
to rotate.
You cannot use rotate sort
with A0 (E), A1(D) originals.
An unsuitable paper size for
rotate sort has been set.
Set paper of the following pa-
per width:
❖
❖❖
❖ Metric version:
•
594 mm and 420 mm (A2)
•
420 mm and 297 mm (A3)
•
297 mm and 210 mm (A4)
❖
❖❖
❖
Inch version (Engineering)
• 8
1
/
2
" and 11" (A)
• 11" and 17" (B)
• 17" and 22" (C)
❖
❖❖
❖
Inch version (Architecture)
• 9" and 12" (A)
• 12" and 18" (B)
• 18" and 24" (C)
Maximum number of
sets is NN
The number of copies exceeds
maximum.
Change the maximum copy
quantity you can make at a
time. See p.85 “Max. Copy
Quantity”.
Original was misfed
at following point.
Open the part as
shown, then remove
it.
The original has jammed
(original misfeed).
Follow the on-screen instruc-
tions to remove the jammed
original. See “xClearing Mis-
feeds”, General Settings Guide.
Paper was misfed at
following point.
Open the part as
shown and remove it.
The copy paper has jammed. Follow the on-screen instruc-
tions to remove the jammed
paper. See “xClearing Mis-
feeds”, General Settings Guide.
Add Toner
The machine is running out of
toner.
Follow the on-screen instruc-
tions to change the toner car-
tridge. See “DAdding
Toner”, General Settings Guide.
Cover is open as
shown.Close it.
The cover shown on the dis-
play is open.
Close the cover as shown.
Used Toner Bottle is
full.
Used Toner Bottle is full. Call your service representa-
tive.
Message Problem/Causes Solutions
DolphinC2_ENcopy_F_FM.book Page 68 Friday, February 25, 2005 10:46 AM
