Basics
16
1
❒
When inserting long length orig-
inals,
there may be some move-
ment to either side. If this
happens, correct the movement
manually while feeding the
originals into the machine.
C
CC
C
Press the {
{{
{#}
}}
} key after all origi-
nals have been scanned.
-
--
-To stop originals feeding in
If the originals are feeding in slanted,
or jamming, etc., press the {
{{
{Scanner
Stop}
}}
} key to stop them feeding in.
Note
❒ When you press the {
{{
{Scanner Stop}
}}
}
key, the original stops immediate-
ly, which can cause it to jam. If this
happens, see “xClearing Mis-
feeds”, General Settings Guide.
❒ When you have set rear original
exit as the original output location,
the rear edge of the originals are
held at the output exit. To cancel
this, press the {
{{
{Scanner Stop}
}}
} key.
See p.8 “Original Output Loca-
tions”.
Original Orientation
Place the original of the same orienta-
tion as the copy paper on the original
table.
1.
Feeding direction
When you cannot place the original
as the above, you may not make cop-
ies as you want with particular func-
tions. If this happens, change the
orientation by selecting [] or [].
Note
❒ It is recommended that you use
this function together with the
Auto Paper Select or Preset Re-
duce/Enlarge function.
A
AA
A
Press [Orientation/Custom].
B
BB
B
Select the original orientation,
and then press [OK].
ZEDH150E
AHD005S
DolphinC2_ENcopy_F_FM.book Page 16 Friday, February 25, 2005 10:46 AM
