Filter
Top Products
PERF SONG PATTERN MIX MASTER REMOTE UTILITY
QUICK SET
FILEVOICE
MOXF6/MOXF8 Reference Manual
Utility Mode
[F1] GENERAL
[F2] VOICE
[F2] SEQ
[F3] VCE A/D
[F4] CTL ASN
[F5] USB I/O
[F6] MIDI
Utility Job
143
Knob DispTime (Knob Display Time)
Determines whether or not the KNOB FUNCTION pop-up window appears when operating the Knobs, and how long the
popup will continue to be shown.
Settings: off, 1 sec, 1.5 sec, 2 sec, 3 sec, 4 sec, 5 sec, keep
off.......................When this selected, the popup is not called up even if you operate the Knobs.
1 sec – 5 sec.....Turning the Knob will cause the popup to appear after an elapsed time of between 1 – 5 seconds, and then
automatically close.
keep...................Operating the Knob will cause the popup to be shown continuously until you call up a different display/dialog/
popup or press the [ENTER]/[EXIT] button.
KNOB FUNCTION pop-up window appears when operating the Knobs
Knob Curve
Adjusts the touch response sensitivity in five steps. Larger values provide higher sensitivity, letting you make large
changes to the actual value even with slight turning of the Knob.
Settings: table1 – table5
LCD Mode
Switches the backlight of the LCD.
Settings: normal, reverse
LCD Contrast
Adjusts the LCD contrast.
Settings: 1 – 16
These special Voice-related settings are available only when entering the Utility mode from the Voice mode, letting you
set parameters related to all the Voices.
[SF1] MFX (Master Effect)
From this display you can set the Master Effect related parameters applied to all the Voices. Details on each parameter
are the same as in Performance Common Edit. See page 60.
[SF2] MEQ (Master EQ)
From this display you can apply five-band equalization (LOW, LOW MID, MID, HIGH MID, HIGH) to all Voices. Details on
each parameter are the same as in Performance Common Edit. See page 61.
[SF3] ARP CH (Arpeggio Channel)
MIDIOutSwitch (MIDI Output Switch)
This enables or disables MIDI data output for the Arpeggio function. When this is set to “on,” Arpeggio data is sent via
MIDI in the Voice mode.
Settings: off, on
TransmitCh (Transmit Channel)
Determines the MIDI channel through which Arpeggio playback data will be sent (when Output Switch above is on).
Settings: 1 – 16
[F2] VOICE