Filter
Top Products
PERF SONG PATTERN MIX MASTER REMOTE UTILITY
QUICK SET
FILEVOICE
MOXF6/MOXF8 Reference Manual
Mixing Mode
Mixing Play
[F1] VOL/PAN
[F2] VOICE
[F3] EF SEND
[F4] TEMPLATE
[F5] VCE ED
[F6] EFFECT
Mixing Edit
Common Edit
[F1] GENERAL
[F2] MFX
[F3] MEQ
[F4] USB I/O
[F5] A/D IN
[F6] EFFECT
Part Edit
[F1] VOICE
[F2] OUTPUT
[F3] EQ
[F4] TONE
[F5] RCV SW
Mixing Job
[F1] INIT
[F2] RECALL
[F3] COPY
[F4] BULK
Mixing Voice Edit
Common Edit
[F1] GENERAL
[F2] OUTPUT
[F4] CTL SET
[F5] LFO
[F6] EFFECT
Element Edit
[F1] OSC
[F2] PITCH
[F3] FILTER
[F4] AMP
[F5] LFO
[F6] EQ
Mixing Voice Job
[F2] RECALL
[F3] COPY
[F5] DELETE
Supplementary Information
114
Mixing Mode
The settings of the tone generator block for Song/Pattern playback are collectively referred to as a Mixing. The Mixing
mode lets you change the Voice and effect settings for each Part. This section explains each parameter in four types
(Mixing Play, Mixing Edit, Mixing Job, and Mixing Voice Edit). Keep in mind that Pattern Mixing parameters are not
actually part of the Pattern sequence data in each Track, but rather are settings for the tone generator, as it is played
back by the Pattern data. As such, the Mixing parameter settings are not recorded to the Song/Pattern Tracks.
NOTICE
The settings in Mixing Play/Mixing Edit are stored as part of Song/Pattern data.
NOTE Parameter settings in Mixing Play and Mixing Edit can be stored as a template to internal Flash ROM, as well as being stored as
part of a Song/Pattern. For details, see page 126.
Mixing Play
The Mixing Play display will appear when pressing the [MIXING] button in the Song mode or Pattern mode. Here you
can edit the Mixing parameters which are important for creating a Song/Pattern.
PAN
Determines the stereo pan position for each part.
Settings: L63 (far left) – C (center) – R63 (far right)
VOLUME
Determines the volume for each Part allowing you to set the optimum level balance of all the Parts.
Settings: 0 – 127
VOICENUM (Voice Number)
BANK MSB/LSB (Bank Select MSB/LSB)
Determines the Voice for each Part. Mixing Voices can also be selected.
NOTE
The Category Search function can also be used to select Voices here, except for Mixing Voices.
P.With Vce (Pa ra mete r with Voice)
Determines whether or not the following parameter settings of the selected Voice are copied from the Voice to the
current Part when you change a Voice for the current Part individually.
•Arpeggio settings
• Filter Cutoff Frequency
•Filter Resonance
•Amplitude EG
•Filter EG
•Pitch Bend Range (Upper/Lower)
•Note Shift
NOTE
Regardless of the “P.WithVce” setting, the following settings are always copied when a Normal Voice is selected: “Mono/Poly,”
“Switch” (Portamento Part Switch), “Time” (Portamento Time) and “Mode” (Portamento Mode).
Settings: off (not copied), on (copied)
Operation
[SONG]/[PATTERN] Song/Pattern selection [MIXING]
[F1] VOL/PAN (Volume/Pan)
[F2] VOICE
Knob
Knob