Filter
Top Products
User’s Manual 3-23
Hardware, Utilities and Options
Installing a memory module
To install a memory module, follow the steps as detailed below:
1. Shut down the computer - make sure the Power indicator is off (refer to
the Turning off the power section in Chapter 1, Getting Started if
required).
2. Remove the AC adaptor and all cables and peripherals connected to
the computer.
3. Close the display panel.
4. Turn the computer upside down and remove the battery pack (refer to
the Replacing the battery pack section in Chapter 6, Power and Power-
Up Modes, if required).
5. PORTÉGÉ R600: Loosen the two screws securing the memory module
cover in place - please note that this screw is attached to the cover in
order to prevent it from being lost.
PORTÉGÉ A600: Loosen the one screw securing the memory module
cover in place - please note that this screw is attached to the cover in
order to prevent it from being lost.
6. Slide your fingernail or a thin object under the cover and lift it off.
Figure 3-9 Removing the memory module cover (PORTÉGÉ R600)
Figure 3-10 Removing the memory module cover (PORTÉGÉ A600)
Use a point size 0 Phillips screwdriver.
Screws
Memory
module cover
Screw
Memory
module cover