Filter
Top Products
30
PROBLEM: The walking belt is off-center or slips when walked on
SOLUTION: a. If the walking belt is off-center, remove the key and
U
NPLUG THE POWER CORD. If the walking belt
has shifted to the left, use the hex key to turn the
l
eft idler roller bolt clockwise 1/2 of a turn; if the
walking belt has shifted to the right, turn the left
idler roller bolt counterclockwise 1/2 of a turn. Be
careful not to overtighten the walking belt. Plug in the
power cord, insert the key, and run the treadmill for a
few minutes. Repeat until the walking belt is cen-
tered.
b. If the walking belt slips when walked on, first remove
the key and UNPLUG THE POWER CORD. Using
the hex key, turn both idler roller bolts clockwise, 1/4
of a turn. When the walking belt is correctly tight-
ened, you should be able to lift each edge of the
walking belt 3 to 4 in. (8 to 10 cm) off the walking
platform. Be careful to keep the walking belt cen-
tered. Then, plug in the power cord, insert the key,
and carefully walk on the treadmill for a few minutes.
Repeat until the walking belt is properly tightened.
PROBLEM: The treadmill will not connect to the wireless network
SOLUTION: a. Perform a network test (see step 9 on page 25).
b. Make sure the wireless settings on your console are correct (see step 2 on page 22).
c. Make sure the settings for your wireless network are correct.
d. If you still have questions, see the front cover of this manual.
PROBLEM: The buttons on the screen do not work correctly
SOLUTION: a. If the screen is not properly calibrated, it will be difficult to touch the correct buttons on the screen.
To calibrate the screen, see step 7 on page 25.
b
a