Filter
Top Products
Appendix C Generating 2167A Documents Using FrameMaker
© National Instruments Corporation C-5 DocumentIt User Guide
Changing the Generic Title Page
The MML file that you have generated—in this case,
controller_logic_mil.mml—includes a generic title page that
appears as shown in Figure C-1 after it is imported into FrameMaker. If you
want to change the data on the title page, you can accomplish this in one of
the three following ways:
• Using a text editor, you can edit the
fmmil.tpl data. Figure C-2
shows the data in the
fmmil.tpl file that produces the title page
shown in Figure C-1. You should make these changes to
fmmil.tpl
before you generate the document from SystemBuild. All subsequent
documents generated by DocumentIt using
fmmil.tpl will continue
to have your new title page until you change the contents of
fmmil.tpl again.
• Using a text editor, you can edit the MML output file you have just
generated. Figure C-2 shows the data in the example file
controller_logic_mil.mml that produces the title page shown in
Figure C-1. If you regenerate the document, you will have to edit this
file again.
• If you are familiar with FrameMaker, you can edit the title page after
you import the data into FrameMaker.
Note If your output files contain less than (<) or more than (>) characters from your
model, you must use your text editor to place a backslash (
\) character in front of these
characters. This is required because these characters will otherwise be interpreted as
invalid MML commands when the
*.mml file is imported into FrameMaker.