Filter
Top Products
Black plate (281,1)
9. Say: [Beep] “XXXX” (Speak an
arbitrary 4-digit pairing code. This can
be any combination of 4 numbers.)
NOTE
l
Some devices accept only a particular
pairing code (Usually, “0000” or “1234”).
If pairing cannot be completed, refer to the
owner's manual of your mobile device, and
try those numbers if necessary.
l
Record the code as it will be used to
program your phone in Step 16.
10. Prompt: “Pairing code XXXX (4-
digit number). Is this correct?”
11. Say: [Beep] “Yes” or “No”
12. If “Yes”, go to Step 13.
If “No”, the procedure returns to Step
8.
13. Prompt: “Start pairing procedure on
phone. See phone's manual for
instructions.”
14. Using the mobile telephone, perform
a search for the Bluetooth
®
device
(Peripheral device).
NOTE
For the operation of the mobile telephone,
refer to its instruction manual.
15. Select “Mazda” from the device list
searched by the mobile phone.
16. Input the 4-digit pairing code set in
Step 9 to the mobile telephone.
17. Prompt: “Please say the name of the
phone after the beep.”
18. Say: [Beep] “XXXX - - -” (Speak a
“phone tag”, an arbitrary name for the
phone.)
Example: “Stan's phone.”
NOTE
Speak a programmed “phone tag” within 10
seconds.
If more than two mobile telephones are to be
programmed, they cannot be programmed with
the same or similar “phone tag”.
19. Prompt: “Adding XXXXXX - - -
(Ex. “Stan's phone”) (Phone tag). Is
this correct?”
20. Say: [Beep] “Yes”
21. Prompt: “Assign a priority for this
phone between 1 and 7, where 1 is
the phone used most often.”
22. Say: [Beep] “1” (Speak a number of
the desired priority from 1 to 7.)
NOTE
l
Normally, “1” is to be input (Highest
priority).
l
If more than two mobile telephones are
registered, input the priority order from 1 to
7.
23. Prompt: “XXXXXX - - - (Ex.
“Stan's phone”) (Phone tag) set to
priority X (Priority number). Is this
correct?”
24. Say: [Beep] “Yes”
25. Prompt: “Pairing complete”
After a mobile telephone is registered, the
system automatically identifies the phone.
By pressing the voice recognition/hands-
free switch again, or by pressing the voice
recognition/hands-free switch first after
switching the ignition from OFF to ACC,
the system reads out a voice guidance,
“XXXXXX - - - (Ex. “Stan's phone”)
(Phone tag) is connected”. If two or more
telephones are registered, the one with the
highest priority is selected.
Interior Comfort
Bluetooth® Hands-Free
6-67
MX-5_8DG6-EA-13F_Edition1 Page281
Thursday, May 30 2013 10:51 AM
Form No.8DG6-EA-13F