Filter
Top Products
Black plate (256,1)
(Master code input determination)
5. Determine the master code which has
been input by pressing the scan button
(
).
6. “PIN CLEAR ED” appears which
indicates that the master code input has
been completed.
7. The ID code is set to the default [0000]
and the initialization process is
completed.
NOTE
Master code:
The Master Code is used to initialize or re-
initialize the ID code in the event that the code
is not set to [0000] and/or the personalized ID
code is not known. The initialization process
resets the ID code to [0000]. The master code
can potentially defeat the intent of the security
of the parental lock if it is located by persons
not authorized by the owner to access certain
channels.
SIRIUS Satellite Radio Master Code: [0913]
NOTE
l
When a numeric value other than the
master code is input and the scan button
(
) is pressed, “SR1 Err” is displayed
and then it returns to the “SR1----”
display again.
l
If an ID code is not input for ten seconds,
“Err” is displayed and it returns to the
former display.
l
Channel preset buttons 1, 2, 3, 4 and the
scan button (
) are used for inputting
the ID code. Buttons 5 and 6 cannot be
used.
Change of ID code
Setting condition: SAT mode
When changing the ID code, the new ID
code is input after the previous one is
input first.
(Registered ID code input)
1. Press and hold the scan button (
),
then press channel preset button 5.
Hold both buttons together for 1.5
seconds.
2. “ENTER PIN” appears for three
seconds which indicates that it is in
code input mode.
3. “SR1 - - - -” appears, which indicates
that it is ready for code input.
4. Input the registered ID code using
channel preset buttons 1-4.
Example: When the registered ID code
is “2323”, input “2323”. At this time
“SR1 2323” is displayed.
Press 1 for the first digit, 2 for the
second, 3 for the third, and 4 for the
last digit. For example, if your number
is 2323, press 1 three times (includes
0), 2 four times, 3 three times, and 4
four times. If the display goes off while
inputting, begin from Step 1.
NOTE
The registered ID code is the default [0000] at
the time of factory shipment. If [0000] results
in “Err” on the display, go to the
“INITIALIZATION OF ID CODE” section to
reset to [0000].
(Verification with the registered ID
code)
5. Determine the input code by pressing
the scan button (
).
6. If it does not match with the previously
registered code, “SR1 Err” is displayed
and then it returns to “SR1 - - - -”.
6-42
Interior Comfort
Audio System
MX-5_8DG6-EA-13F_Edition1 Page256
Thursday, May 30 2013 10:51 AM
Form No.8DG6-EA-13F