Filter
Top Products
3
• This product is NOT a substitute for direct
supervision of your baby. Check your baby’s
activities at regular intervals. Monitoring of
premature babies, or those considered to be
at risk, should always be carried out under
the supervision of a health professional.
• Always place both the Nursery Unit and
Parents’ Unit on a flat surface in an upright
position and allow for proper ventilation.
• Avoid damage to the Sensor Pad cord and
to the adapter cords. Route cords so that
they are not likely to be walked on or pinched
by items placed on or against them.
• Route sensor pad cord only below crib
matress and out of reach of children.
• Use ONLY AAA (LR03) batteries (not
included) and/or the AC adapters provided for
the Parents’ Units.
• During long periods of non-use remove all
batteries from their compartments and unplug
the AC adapters.
• This monitor uses public airwaves to
transmit signals. The Parents’ Unit may pick
up signals or interference from other nursery
monitors in your area. Your monitor may even
be picked up by other households. To protect
your privacy, make sure both units are turned
off when not in use. If you experience
interference, change the channel on both
units.
• When the monitor is in use, do not use a
crib mobile or other crib accessories that may
produce vibrations. Other sources of
vibrations may include fans, washing
machines, loud music, etc. These sources of
vibration may interfere with the performance
of your Angelcare® monitor and the alarm
will not sound if it continues to detect any
movement other than your baby’s. Be sure all
vibration sources are eliminated before using
the monitor.
• You may experience false alarms for
several reasons. The most common reason is
the Nursery Unit has not been turned off after
you have removed your baby from the crib.
Another reason is the Sensor Pad has not
been placed under the mattress properly. Be
sure the Sensor Pad is on a flat, firm surface
with the turquoise side facing up.
The sensitivity level may also need to be
adjusted. Refer to the Movement Sensitivity
Adjustment section on Pg. 11.
• Always be sure to immediately check on
baby whenever an alarm sounds.
• Your monitor can be used in any crib that is
stationary and designed to safely hold a baby.
If your crib has a spring or slat base you will
need to place a piece of Masonite board
under the Sensor Pad. This support must be
at least 13 inches long on all four sides and
1/4 inch thick. Only use your Angelcare®
monitor in a stationary sleeping environment
such as a crib where the Sensor Pad can rest
on a completely flat, firm surface.