Filter
Top Products
10
Sound &
Mo
vement
Sound
Only
Ti
c
O
Sensor
Pa
d
Sensitivit
y
Nursery
Unit
Model #AC201
1
Sound & Movement
• Sound & Movement: You will be able to hear your baby's
sounds, see sound lights, and hear a “Tic” sound with every
movement your baby makes. If no movement is detected, the
“Tic” will stop and after 20 seconds the alarm will sound.
NOTE: Make Sure your Sensor Pad is set up before proceeding with this section. If you haven't set up your
Sensor Pad please go to Pg.8 for instructions on how to properly set up the Sensor Pad.
Switch the Nursery Unit to the "Sound & Movement" function. Turn the Parents' Unit ON by selecting either
channel "A" or "B". Make sure it is set to the same channel as the Nursery Unit. The Movement Indicator Light on
the Nursery Unit will flash red, green, and then emit a single "Tic" sound. Gently pat your hand on the mattress.
The green Movement Indicator Light will continue to flash with every movement. The Nursery Unit will also tick with
every movement.
Remove your hand from the mattress. Due to no movement, the ticking will stop, the Movement Indicator Light will
stop flashing, and a pre-alarm beep will sound after 15 seconds. Five seconds later the alarm will sound and the
red Alarm Indicator Light will flash continuously.
Tic Off
You can also test for movement with the Nursery Unit set to the “Tic Off” position. In this case, you will not hear a
constant ticking when you touch the mattress. When you remove your hand from the mattress the Movement
Indicator Light will stop flashing, a pre-alarm beep will sound after 15 seconds, and five seconds later the alarm will
sound and the red Alarm Indicator Light will flash continuously.
To turn off the alarm, turn the Nursery Unit off or pat your hand lightly on the mattress so the Sensor Pad will
redetect movement. The red Alarm Indicator Light on the Nursery Unit will continue to flash for one minute and it
will then revert to green.
If the alarm does not sound when you are not touching the mattress, the Sensor Pad may be detecting a
continuous vibration from another source from inside and/or outside your baby's room. Common sources of this
interference are crib mobiles, fans, washing machines, or even loud music. Therefore, it is very important to make
sure all vibration sources are eliminated before using the monitor. Place the crib near a solid supporting
wall and away from strong air currents. Do not use crib mobiles or accessories that may cause vibrations. Avoid
contact with the crib when the monitor is in use. If you find the alarm will still not sound when you are not touching
the mattress or crib, the monitor is on, and you have removed all external sources of vibration, the sensitivity level
may need to be decreased. Please refer to the Movement Sensitivity Adjustment section on page 11.