Filter
Top Products
5
Infant Seat/Rocker Assembly
Seat Back Tube
Sockets
PRESS
• Insert the seat back tube into the socket in each side rail.
• While pressing the tabs on the ends of the seat back tube,
continue to insert the seat back tube into the sockets in each
side rail until the tabs “snap” into place. Make sure you hear
a “snap” on each side.
• Pull the seat back tube up to be sure it is secure in the side
rail sockets.
5
Kickstand
• While pressing the tab on each end of the kickstand, insert the
kickstand into the small tube inside each side rail.
Hint: The kickstand is designed to fit into the siderails one way.
If you cannot insert it into the small tubes (inside the side rails),
turn it around and re-insert it into the small tubes.
• Push the kickstand into the small tubes until the tabs “snap”
into place. Make sure you hear a “snap” on each side.
• Pull the kickstand to be sure it is secure in each side rail.
6
PRESS
PRESS
Lower Pocket
Hardboard
• Fit the upper pocket on the pad onto the seat back tube.
• Turn the hardboard over and insert it into the slot in the front
edge of the pad.
Seat Back Tube
Upper Pocket
7