Filter
Top Products
4
Infant Seat/Rocker Assembly
This package contains small parts
in its unassembled state.
Adult assembly is required.
CAUTION
• Locate the hole in each side rail.
• Position the front tube so that it is a shape.
• Fit the front tube to the side rails, as shown. Hold the front tube
in place and proceed to step 3.
Side Rail Hole
Front Tube
2
• While pressing the tab on each end of the cross brace, insert the
cross brace into the side rails, as shown. Make sure you hear
a “snap” on each side.
1
Cross Brace
PRESS
PRESS
PRESS
Side Rails
• Insert a M5 x 2,9 cm screw through the outside of each side rail
and into the ends of the front tube.
IMPORTANT! Please follow the next assembly (step 4) carefully to
completely secure the front tube to the side rails.
Front Tube
Side Rail Hole
Side Rail Hole
3
• Fit a retainer with lock nut onto the end of a screw and to the
inside of a side rail. Tighten the screw using the assembly tool.
Turn the tool clockwise to tighten.
Hint: A lock nut has been factory assembled to the retainer.
During shipment, the lock nut may have fallen out of the retainer.
If it has, please fit it into the hexagonal hole in the retainer so that
the rounded side of the lock nut faces out.
• Repeat this procedure to fasten the screw to the other end of
the front tube and side rail using another retainer with lock nut.
Retainer with Lock Nut
4