Filter
Top Products
1-10 Rack Installation Guide
!!%"#$
7. Repeat steps 3 through 7 for the remaining slide assembly on the other side of
the rack.
Installing the Storage System in the Rack
WARNING: If you are installing more than one PowerVault system, install
the heaviest system in the lowest available position in the rack.
WARNING: Never pull more than one component out of the rack at a time.
1. Lift the storage system into position.
CAUTION: Because of the size and weight of the system, never attempt to
install the system in the slide assemblies by yourself.
2. Tilt the rear of the storage system upward and position the flange on the rail
assemblies inside the mounting channels on both sides of the system.
3. Tilt the front of the storage system upward and push the system into the rack
until the mounting plate on the system rests against the vertical rails (see
Figure 1-9).
4. Tighten the captive thumbscrews to each rack adapter bracket.
Figure 1-9. Installing the Storage System in the Rack
mounting
hooks (2)