Filter
Top Products
1-6 Rack Installation Guide
!!%"#$
Figure 1-5. Removing the 24-U Rack Doors
CAUTION: Store the two doors where they will not injure someone if the
doors accidently fall over.
If you want to reverse the door so that the handle is on the other side, perform the fol-
lowing steps:
1. With the door open, lift out and fully retract all hinge pins.
2. Remove the hinges and door brackets from the door frame.
3. Replace the hinges and door brackets on the opposite side and switch the posi-
tion of the handle.
4. Replace the rack door (see the section, “Replacing the Rack Doors,” found later
in this guide).
Installing the Rail Slide Assemblies in the Rack
NOTE: If the slide assemblies were preinstalled by Dell, you can skip to the section,
“Installing the Storage System in the Rack,” found later in this guide.
Use the 3-U rack template to determine where you want to install the slide assem-
blies. The rack template is the same height as the system chassis.
hinge insert
hinge
hinge pin