Filter
Top Products
Installation with Lap And Shoulder Belts:
• When using vehicle lap and shoulder belts, shoulder belt may
be used for additional support. Place shoulder belt around
back of Combi Connection™ (fig. e) and through the vehicle
shoulder belt guide on back of car seat shell (fig. f). If
shoulder belt is too short to go around back of Combi
Connection™, position shoulder belt against vehicle seat
back (fig. g). Do not route shoulder belt through lap belt
guides on either side of car seat.
• Lap/shoulder belt with free sliding latch plate:
- Pull out on latch plate (fig. h). If belt slides freely
through latch plate, a locking clip must be used as
described in “Locking Clip” section.
- Some combination lap/shoulder belts with free sliding
latch plates may be converted into an “automatic
locking mode” that will allow use without a locking clip.
See vehicle owner’s manual and label on vehicle belts
for instructions.
34
(fig. e) (fig. f)
(fig. g) (fig. h)
Shoulder
Belt Guide
8040 (EN) 122904.qxd 12/29/04 9:17 PM Page 35