Filter
Top Products
27
L
ATCH connectors will properly connect
with LATCH anchor in the vehicle only
when connectors are correctly aligned and
harness is not twisted.
To ensure LATCH connector is properly
aligned with vehicle’s LATCH anchor, the
connector’s red release button should face
away from vehicle seat back, and the larger
of the two connector sections is on top
(fig. A).
If LATCH connector will not properly
connect to LATCH anchor in the vehicle,
LATCH straps are twisted, or a positive click
is not heard, connectors must be switched
from one side to the other. This will ensure
that connectors are correctly aligned.
Lift front of cover to access LATCH
connector.
Slide both connectors through rear-
facing belt slots to center of restraint so
both connectors are on the front side of
restraint (fig. B).
Loosen loop on one connector (fig. C).
Thread the other connector through
loop created in step 3 to switch positions
(fig. D).
Slide each connector through the
appropriate rear-facing belt slot to
opposite side of restraint.
Replace cover and continue with
installation procedure.
1�
2�
3�
4�
5�
6�
Switching the LATCH Connector
B
C
Top
Release Button
A
Restraint Functions
D