Filter
Top Products
20
Figure A illustrates a typical forward-facing lap/
shoulder-belt installation.
When not in use, always store LATCH connectors
in storage slots.
Place child restraint forward facing on
vehicle seat.
Restraint must be in full upright position
when installed in forward-facing mode with
children over 33 pounds (15 kg.).
Britax recommends use of Versa-Tether®
to improve installation. Remove Versa-
Tether from pouch and loosely attach to an
approved tether-anchorage point (pg. 24).
Pull vehicle belt out, then thread it over
LATCH bar and through the forward-
facing belt path (fig. B).
Verify that vehicle belt is not twisted
and is routed over LATCH bars, then
buckle (fig. C).
Rotate lever downward to open
forward-facing lock-off farthest from
where vehicle belt will be buckled.
Remove slack from lap portion of
vehicle belt.
Kneel on child restraint to push it into
vehicle seat while pulling shoulder
portion of vehicle belt tightly through
lock-off (fig. D).
•
•
1�
•
•
2�
3�
4�
5�
6�
Lap/Shoulder Belt Installation
Installation: Forward Facing
A
B
C