Filter
Top Products
16
Figure A illustrates a typical rear-facing, lap-belt
installation.
When not in use, always store LATCH connectors
in storage slots. (See page 28).
Fully recline restraint, then place it rear
facing on vehicle seat.
Lift cover and open rear-facing lock-off
farthest from where vehicle belt will be
buckled. (fig. B)
Pull vehicle belt out, then pass it through
farthest rear-facing belt slot from where
vehicle belt will be buckled (fig. C).
The vehicle belt can be routed over or under
restraint cover.
Route vehicle belt across restraint seat
then through second rear-facing belt slot.
Verify vehicle belt is not twisted, then
buckle (fig. D).
Push child restraint firmly into vehicle seat
while removing slack from vehicle belt.
Position vehicle belt through lock-off arm
(fig. E), tighten belt, close lock-off arm
and replace cover.
Lock-off is properly closed when a click is
heard.
To prevent breakage, never extend lock-off arm
beyond its natural open position and always
keep lock-off closed when not in use.
•
•
1�
2�
3�
•
4�
5�
6�
7�
•
•
Lap-Belt Installation
Installation: Rear Facing
A
B
C
WARNING!
Do not install with non-locking (ELR),
2-point vehicle belt.