Filter
Top Products
22
Figure A illustrates a typical forward-facing, lap-belt
installation.
When not in use, always store LATCH connectors in
storage slots.
Place child restraint forward facing on vehicle
seat.
Restraint must be in full upright position when
installed in forward-facing mode with children over 33
pounds (15 kg.).
Britax recommends use of Versa-Tether® to improve
installation. Remove Versa-Tether from pouch and
loosely attach to an approved tether-anchorage point
(pg. 24).
Pull vehicle belt out, then pass it under LATCH
bar, through forward-facing belt slots, then
under LATCH bar on the other side (fig. A).
Verify vehicle belt is not twisted, is routed
under LATCH bars, then buckle (fig. B).
Kneel on child restraint to push it into vehicle
seat while removing slack from vehicle belt
(fig. C).
Remove slack from Versa-Tether and store
excess webbing in tether pouch.
Verify all connections are secure and that
restraint is stable. The restraint is secure when
it cannot be moved front to back or side to
side more than 1” (2.5 cm.) at belt path. If
restraint is not secure, repeat procedure or
use an alternate seating location.
•
•
1�
•
•
2�
3�
4�
5�
6�
Lap-Belt Installation
Installation: Forward Facing
A
B
C
WARNING!
Do not install with
non-locking (ELR) two-point vehicle belt.