Filter
Top Products
25
Because every vehicle model is different, sometimes
you cannot find a location to properly anchor the
tether, or the structural part of seat is too large
for the hook. Use rear-facing tether connector strap (fig. D) to assist in
creating an anchor point.
Find a fixed vehicle seat belt anchor or vehicle seat leg (that is bolted
to the floor) to which the strap can be wrapped around.
If you cannot find an acceptable location to create an anchor point,
contact vehicle manufacturer to identify a suitable tether connection
point.
Loop strap around metal anchor.
Take metal D-ring and thread it through webbing loop on other end
of strap.
Pull metal D-ring all the way through until strap is tight around metal
anchor.
Use D-ring as an attachment point for hook on tether strap.
1�
2�
3�
4�
5�
6�
WARNING!
Only use tether connector
strap for rear-facing tether installation.
Installation: Versa-Tether
®
Rear-Facing Tether Connector Strap
D
The rear-facing recline angle can be adjusted by placing a
rolled towel or pool noodle crease of the vehicle seat, and
restraint can be stabilized by tightening tether as shown
in figure C, using anchor point 3.
It may be necessary to loosen tether and vehicle seat belt
before adjusting recline position.
•
•
NOTE:
The rear-facing recline angle of the
child restraint should be 30º-45º
from vertical (not to exceed 45º from
vertical) when car is parked on a level
•