Filter
Top Products
18
Top
Figure A illustrates a typical forward-facing LATCH
installation.
Verify that your vehicle is equipped with LATCH anchors.
If LATCH anchors are not available, you must use vehicle
belt installation methods.
NOTE: LATCH connectors must be in an upright
position (as shown in figure B) and strap should be
tight and not twisted to ensure proper installation.
If stored, remove LATCH connectors from storage
slots under cover (see page 28).
Press and hold first LATCH adjuster button,
then pull LATCH strap to full length. Repeat for
remaining LATCH connector.
Place restraint sideways on vehicle seat, with back
of restraint facing toward you.
Restraint must be in full upright position when
installed in forward-facing mode with children over
33 pounds (15 kg.).
Britax recommends use of Versa-Tether® to improve
installation. Remove Versa-Tether from pouch and
loosely attach to an approved tether-anchorage point
(see page 24).
Verify LATCH strap is not twisted, then attach
closest LATCH connector to vehicle seat back to
farthest LATCH anchor from you (fig. C).
NOTE: It may be necessary to switch LATCH
connectors as shown on page 27 if ANY of the
following conditions exist:
LATCH connector is not in an upright position as
shown in figure B.
LATCH strap is twisted.
A positive click is NOT heard when LATCH connector
and LATCH anchor are connected.
NOTE: If a positive click is not heard, but LATCH
connector is in an upright position, you should not
switch LATCH connector. The strap may be too tight or twisted, or there may be
debris in LATCH connector.
•
•
1�
2�
3�
•
•
4�
•
•
•
•
LATCH Installation
Installation: Forward Facing
A
B
C