Filter
Top Products
Operation26
Operation
Start up
1. Plug the power cord into the projector and into a
wall socket. Turn on the wall socket switch
(where fitted). Check that the Power indicator
on the projector lights orange after power has
been applied.
2. Slide the lens cover open. If it is closed, it could
become deformed due to the heat produced by the
projection lamp.
3. Press Power on the projector or remote
control to start the projector. As soon as the
lamp lights up, a "Power On Tone" will be
heard. The Power indicator light flashes green
and stays green when the projector is on.
The start up procedure takes about 30
seconds. In the later stage of start up, a startup
logo is projected.
(If necessary) Rotate the focus ring to adjust
the image clearness.
If the projector is still hot from previous activity, it will run the cooling fan for approximately 90
seconds before energizing the lamp.
4. If you are prompted for a password, press the arrow buttons to enter a six digit
password. See "Utilizing the power-on lock function" on page 27 for details.
5. Switch all of the connected equipment on.
6. The projector will start to search for input signals. The current input source being
scanned displays in the upper left corner of the screen. If the projector doesn't detect a
valid signal, the 'No Signal' message will continue displaying until an input source
signal is found.
You can also press SOURCE on the projector or remote control to select your desired
input signal. See "Switching input signal" on page 29 for details.
If the frequency/resolution of the input signal exceeds the projector's operating range, you will
see the message 'Out of Range' displayed on a blank screen. Please change to an input signal
which is compatible with the projector's resolution or set the input signal to a lower setting.
See "Timing chart" on page 61 for details.
I
I