Filter
Top Products
1. Locate a LATCH seating position as identied in your vehicle
owner’s manual. Some LATCH seating positions may require
deploying of anchors, or installation of guides.
2. Remove the Safety Seat from the base by squeezing the base
release handle located under the center of the foot end of the
Safety Seat and lifting upward on the Safety Seat. (Fig. 25-1)
3. Remove the
LATCH
connectors from
their storage position inside the base
(Fig. 44-1). Place the Base in the rear-
facing position in a forward facing vehicle
seat as shown in Fig. 45-1. The Child
must face the rear of the vehicle and
Safety Seat must be placed in a vehicle
seat that faces forward.
4. Locate the
LATCH
anchors in the vehicle
seat. (Fig. 44-2) Once located, snap the
Safety Seat
LATCH
connectors onto the
steel rod. Listen for the click and check
that both connectors are rmly attached to
the anchor rods by pulling outward on the
connectors. (Fig. 45-2)
5. Proper installation of the Base requires
that the
LATCH
webbing be very tight.
To tighten the webbing, push down hard
with your knee or hand on the Base while
pulling upward on each webbing end.
The webbing will automatically lock in
44
7.0 INSTALLATION
Fig. 44-1
Fig. 44-2
Latch Anchor