Filter
Top Products
3-12 PathBuilder S24x, 26x, and 27x Switch Hardware Installation
Installing DIMs
Installing DIMs
Introduction There are two Data Interface Modules (DIMs) on both the PathBuilder S24x, 26x,
and 27x switch motherboard. Each DIM is a 64-pin, dual in-line module that can be
repositioned so that Ports 1 or 2 act as either DCE or DTE ports. One DIM
corresponds to Port 1 and the other to Port 2.
The DIMs on the motherboard are factory set in the DTE position.
Example Figure 3-4 shows an example of installing a DIM.
Figure 3-4. Installing a DIM
DTE
DCE
Port 1
Port 2
Motherboard
DIMs
Port 1
Port 2