4-22
1
2
3
4
5
6
7
8
9
10
11
10. Tighten the locknut to the specified torque.
NOTICE
ECB00080
Always tighten the locknut against the adjust-
ing nut, and then tighten it to the specified
torque.
11. Place the air filter case in the original position,
install the bolts, and then tighten them to the
specified torque.
12. Connect the air intake duct to the air filter
case, and then tighten the clamp screw at the
air filter case side.
NOTICE
ECB00970
Make sure that the air intake duct is properly
connected to the air filter case, and that the
clamp screw is tightened securely.
13. Install the blow-by gas chamber by installing
the bolt, and then tighten it to the specified
torque.
14. Install the air filter case holding plate by install-
ing the bolts and collars.
15. Connect the coupler.
16. Connect the air intake duct to the throttle
body, and then tighten the clamp screw at the
throttle body side.
NOTICE
ECB00960
Make sure that the air intake duct is properly
connected to the throttle body, and that the
clamp screw is tightened securely.
17. Install the panel.
Rebound damping force
Turn the adjusting screw in direction (a) to increase
the rebound damping force and thereby harden
the damping, and in direction (b) to decrease the
Tightening torque:
Locknut:
30 Nm (3.0 m·kgf, 22 ft·lbf)
Tightening torque:
Bolt:
6.5 Nm (0.7 m·kgf, 4.7 ft·lbf)
Tightening torque:
Bolt:
6.5 Nm (0.7 m·kgf, 4.7 ft·lbf)
