8
IP address
The IP address for the WAP-4060PE.
MAC Address
The hardware or physical address of the WAP-4060PE.
IEEE Standard
The wireless standard or standards used by the WAP-4060PE (e.g.
802.11b, 802.11g)
FW Version
The current Firmware version installed in the WAP-4060PE.
Description
Any extra information for the WAP-4060PE, entered by the administrator.
Note: If the desired device is not listed, check that the device is installed and powered on, then
update the list by clicking the Refresh button.
Buttons
Refresh
Click this button to update the Wireless Access Point device listing
after changing the name or IP Address.
Detail Info
When clicked, additional information about the selected device will
be displayed.
Web Management
Use this button to connect to the WAP-4060PE’s Web-based
management interface.
Set IP Address
Click this button if you want to change the IP Address of the Wire-
less Access Point.
Exit
Exit the Management utility program by clicking this button.
3.2.2 Setup Procedure
1. Select the desired Wireless Access Point from the list.
2. Click the Set IP Address button.
3. If prompted, enter the user name and password. The default values are “admin” for the
User Name, and “password” for the Password.
4. Ensure the IP address, Network Mask, and Gateway settings are correct for your LAN.
Save any changes.
5. The initial IP address setup is now completed. You can click on the “Web Manage-
ment” button to access the web interface of WAP-4060PE for more configurations.
3.3 Setup using a Web Browser
Your Browser must support JavaScript. The configuration program has been tested on the
following browsers:
· Netscape V4.08 or later
· Internet Explorer V4 or later
3.3.1 Setup Procedure
Before proceeding, please install the WAP-4060PE in your LAN, as described previ-
ously.
1. Use a PC which is already connected to your LAN, and start the Web browser.
2. In the Address box, enter the IP address of the WAP-4060PE you want to cobnfig-
ure.
3. You should then see a login prompt, which will ask for a User Name and Password.
Enter admin for the User Name, and password for the Password.
