Event
41
Use the following procedure to configure settings that control command alarm action when an event occurs.
1 Click the [Event] button on the setup menu.
2 On the sub-menu that appears, click [Command alarm].
This will display the command alarm setting window.
3 Configure the settings for each item.
Refer to “Command alarm settings” table for details about the
settings.
• To configure the settings of a command alarm that is not
shown on the display, click the applicable command alarm
number range above the [Set] button to change the
contents of the display.
• Clicking a command number saves the currently
displayed command settings.
4 Click the [Set] button.
Command alarm settings
♦Initial default
Command alarm
Item Settings Description
Rec. cam. Cam.1 to Cam.64 / -- Specifies the channel of the recording camera.
Preset position Number input
(Blank♦)
Specifies the preset position (1 to 256) during alarm input.
• When this setting is blank, the camera does not move to a
preset position.
Output terminal Off / On♦ Specifies whether an alarm signal should be output when an
event occurs.
