Event
38
Use the procedures in this section to configure alarm output duration and buzzer duration settings for when an event (site alarm, terminal alarm,
command alarm) occurs.
1 Click the [Event] button on the setup menu.
2 On the sub-menu that appears, click [Basic].
This displays the event action basic setup window.
3 Configure the settings for each item.
Refer to “Basic event settings” table for details about the
settings.
4 Click the [Set] button.
Basic event settings
♦Initial default
Basics
Item Settings Description
Alarm output Off / 2s♦ / 5s / 10s / 20s / 30s /
1min / Ext / Rec
Specifies the alarm output duration.
• Selecting [Ext] causes alarm output to continue until the
"Alarm [ALM]" button is clicked.
• Selecting [Rec] causes alarm output while event recording is
in progress.
Buzzer duration Off / 2s♦ / 5s / 10s / 20s / 30s /
1min / Ext / Rec
Specifies buzzer duration.
• Selecting [Ext] causes the buzzer to continue to sound until
the "Alarm [ALM]" button is clicked or the [BUZZER STOP]
button on the front panel is pressed.
• Selecting [Rec] causes the buzzer to sound while event
recording is in progress.
